The ideal clipper to do undercut hair for men is one of high quality and high durability. An Andis cordless clipper, for instance, is a popular option. As for corded clippers, an Andis or Oster model is preferable. With a single-length clipper, choose one that is numbered one, two, or three. A clipper set at four or above is usually too long, though some men might want to “test drive” an undercut by getting the short part of their hair clipped with a number four clipper. A clipper numbered at 0 is very short and shaves down to the skin.

To identify a person’s temples, first locate their hairline, the place where their hair meets their forehead. You might also be able to locate the temple based on the position of the ears. The tops of the ears, traced forward to the edges of the face, typically intersect the temples. Trace the hairline to its outer edges on the left and right side. When you notice the hairline angle up and out, you’ve located the upper temple.

Imagine, in other words, drawing a straight horizontal line around the “lid” of the head that passes through the right and left upper temple. Cutting hair below this line short and keeping hair above this line long will allow you to achieve a quality undercut for men. For a more dramatic disconnection, cut the hair higher at the parietal ridge, or the top corner of the head.

If their hair is too short to clip back, use water or a styling product to keep their hair parted.

If you want to fade the undercut, set the clipper to the setting you wish to use. Cut the hair on all sides to a point about halfway to the disconnect line. If you wish to do undercut hair for a man who wants a more dramatic contrast between the hair above and below the disconnect line, just cut all the hair beneath the disconnect line to an even length using the single-length clipper. Use long, steady applications of the clippers and shake off hair that accumulates at the front of the device. This will prevent the clippers from getting clogged, and allow you to see where you’re cutting.

Continue around the back and sides of the head to achieve the same hair length at the same height everywhere. Then, use the comb again at a level just above the one you previously cut. Draw out a slightly longer length of hair, again keeping the teeth of the comb upright. Cut the hair off, again working your way around the entirety of the head to achieve an even length at the level you’ve selected. Continue in this way until the hair below the disconnect line gradually blends into longer hair on all sides of the head. The length you leave the longest hairs of the fade below the disconnect line is up to you. There is no right or wrong length into which you should fade. It is not necessary to fade the hair when doing undercut hair for men. Just ask the recipient of the haircut if they wish to have their hair faded, or if they prefer to keep all hair below the disconnect line at an equal length.

After each application of the clipper, brush the hair straight down with your comb. This will allow you an opportunity to evaluate your handiwork and figure out if you need to cut more or rework the line along which you’re working.

Start by cutting a guide at the back of the hair above the disconnect line. Then, comb the hair from the front of their head back to meet this guide, working with 1 section at a time. Some men like to keep the hair above the disconnect line long and tie it into a topknot or bun. Ask the recipient of the undercut hair for men whether they wish the hair above the disconnect line to remain long.

Wash the hair out in a hairdresser sink. Dry it with a towel.

One potential styling combination is to slick your undercut hair back with styling wax, then blasting it with a hair dryer for twenty to thirty seconds to achieve more volume.

Hair gel tends to be thinner in consistency than pomade and often has a range of holding strengths, from “lightweight” to ‘’heavyweight. ” Gels are easier to wash out of the hair than pomades and waxes.